Home » Soft fruit » Measuring in autumn = less hassle later

Measuring in autumn = less hassle later

Why now?
In autumn and winter, water moves through your soil the most. That is exactly when you see whether your field holds water or drains it, and where the risk of leaching lies. Research shows that the (limited) drainage in rainfed crops occurs mainly in autumn and winter. On extremely wet days, think of 70–90 mm in 24 hours, that percolation can suddenly increase sharply, with a greater chance of nutrient loss.

So what exactly do you measure?
Keep it simple: measure soil moisture at two depths in the root zone. For arable farming, 10–20 cm and 30–40 cm is usually enough to see whether your topsoil and root zone become saturated. Growers in orchards or vineyards add a deep layer (100–200 cm) to know whether you are really building up a reserve in winter for dry periods. Log your rainfall as well (especially 24-hour peaks) and note visible events in the field: puddling, muddy tracks, run-off along paths or slopes.

What do these measurements mean for arable farmers?
If you see moisture remaining at 30–40 cm in winter, you know the field saturates quickly. Then plan fertilisation and tillage so that you do not have unnecessary losses when a wet period follows. Especially with fallow land, a wet autumn like this increases the risk of leaching; a catch crop or a different timing plan helps to limit this. The benefit for your crop plan: your sowing and variety choices in 2026 are based on real field data instead of averages.

And for growers (orchards, vineyards, berries)?
Here, besides water storage, run-off also matters. Field research in sloping row crops shows that grass or ground cover between the rows can reduce annual run-off by roughly more than half. Without cover, in wet autumn or winter months even most of the rainfall can run off, causing erosion and damage. With ground cover you also store more water deeper (down to 1–2 m), without any measured yield loss if you mow in time. That is why it pays growers in particular to measure that deep layer as well: you see whether a winter buffer is really being built up that you can draw on later.

How to tackle it in two weeks
Choose three to five logical spots per field: a high and a low zone, a known wet patch and, with rows, both in the row and between rows. Install your sensors at the depths mentioned, put up a rain gauge and start logging. Note striking moments with date and photo. After a few weeks you will see patterns: where it saturates first, where water stays, and what happens after a peak shower? Based on this, you make two concrete choices for 2026. Arable farmers decide where a catch crop or adjusted fertilisation will be most useful; growers decide where ground cover and the mowing window will deliver the most, and where paths or row direction need a small intervention.

What can you expect?
Not every field changes because of one measurement. The point is that you now see, in the season that matters, what is really happening in your soil. That brings practical gains: less guessing about sowing and fertilisation times, less leaching in wet periods, less mud damage in rows, and more often enough soil moisture when spring starts dry. Where you have slopes or heavy soil that saturates quickly, ground cover usually delivers the biggest improvement; on flat arable land it is more about timing, catch crops and recognising those few wetter spots that cause trouble every year.

Niche note: crops or forage that are sensitive to cadmium can briefly take up more Cd after a heavy rain shower. Only relevant on high-risk fields; monitor more closely there around heavy showers.

Finally
Measuring in autumn is not a hobby; it is making sure your crop plan for 2026 fits your real soil. Measuring at two depths, logging peak showers and events, and recording your management is already enough to make better decisions.

Sources:

  • Jiménez-de-Santiago, D. E., Lidón, A., & Bosch-Serra, À. D. (2019). Soil water dynamics in a rainfed Mediterranean agricultural system. Water, 11(4), 799. https://doi.org/10.3390/w11040799

  • Palese, A. M., Vignozzi, N., Celano, G., Agnelli, A. E., Pagliai, M., & Xiloyannis, C. (2014). Influence of soil management on soil physical characteristics and water storage in a mature rainfed olive orchard. Soil & Tillage Research, 144, 96–109. https://doi.org/10.1016/j.still.2014.07.010

  • Biddoccu, M., Ferraris, S., Pitacco, A., & Cavallo, E. (2017). Temporal variability of soil management effects on soil hydrological properties, runoff and erosion at the field scale in a hillslope vineyard, North-West Italy. Soil & Tillage Research, 165, 46–58. https://doi.org/10.1016/j.still.2016.07.017

  • Ceglar, A., van der Wijngaart, R., de Wit, A., Lecerf, R., Boogaard, H., Seguini, L., van den Berg, M., Toreti, A., Zampieri, M., Fumagalli, D., & Baruth, B. (2019). Improving WOFOST model to simulate winter wheat phenology in Europe: Evaluation and effects on yield. Agricultural Systems, 168, 168–180. https://doi.org/10.1016/j.agsy.2018.05.002

  • Stafford, A., Jeyakumar, P., Hedley, M., & Anderson, C. (2018). Influence of soil moisture status on soil cadmium phytoavailability and accumulation in plantain (Plantago lanceolata). Soil Systems, 2(1), 9. https://doi.org/10.3390/soils2010009

Read also: measuring groundwater levels in agriculture.

Contact

Questions about this topic?

Would you like to know how to measure or apply this in your own business? We are happy to think along with you, with no obligation, and we respond quickly.

Request a quote

Leave your details and we will get in touch.

More from the knowledge base

Scroll to Top